[MR2] MK2 Temperature Sensor

[Dennis McFayden]

Aaron,
 
Thanks for the response. I will check it out. 
 
Dennis

--- On Sun, 2/27/11, Aaron <nitrusmr2 at yahoo.com> wrote:


From: Aaron <nitrusmr2 at yahoo.com>
Subject: Re: [MR2] MK2 Temperature Sensor
To: "Dennis McFayden" <mr2garage at yahoo.com>
Cc: "MR2 Email" <mr2 at mr2.com>
Date: Sunday, February 27, 2011, 5:56 AM


It's on the "sensor tree" that bolts to the drivers side of the cylinder head just in front of the distributor. It's the green 2 pin connector on the front of the tree. FYI the blue single wire connector is for your dash gauge, the black 2 wire is for the cold start injector.  

Aaron 

Sent from my iPad

On Feb 26, 2011, at 11:23 PM, Dennis McFayden <mr2garage at yahoo.com> wrote:

I have a '91 turbo. It runs well but does have a small problem. Just after starting the engine acts like it is running a little lean. It hesitates on acceleration. This hesitation only lasts until the engine warms up. It would appear to be a faulty temperature sensor. Does anyone have an idea where this sensor would be located?

Dennis



_______________________________________________
MR2 Mailing List
MR2 at mr2.com
http://mr2.com/mailman/listinfo/mr2_mr2.com