[MR2] MKII MR2 - Head Gasket Choice

[Joel]

This only make the Cometic gasket an even better option.

The 4AGE has a factory 81mm bore.  My wife's 4AGE has an 83mm bore with 
a 3mm thick Cometic head gasket.

So, again, Cometic can make a custom gasket for you, and their quality 
is top notch.

- Joel -


Aaron Bunch wrote:
> TRD is too thin. It raises compression too much especially after decking the block and resurfacing the head. 
>
> Sent from my iPhone
>
> On Feb 27, 2011, at 11:42 AM, Joseph Obernberger <joeo at lovehorsepower.com> wrote:
>
> Is the TRD one still available?  I had good success with that gasket.
>
> Joe
> http://www.lovehorsepower.com
>
> On 2/27/2011 12:26 PM, Jim Smith wrote:
> Im looking around at head gaskets. My last one was a TTE Steal and was great. Whats the current favs out there that are still available and where did you get yours?
>
> Thanks and I'm sure more questions to come.
>
> BTW - Looking at a new set of JE Pistons and Eagle Rods. Comments?
>
> -Jim Smith
> 91T - SoCal
>
> _______________________________________________
> MR2 Mailing List
> MR2 at mr2.com
> http://mr2.com/mailman/listinfo/mr2_mr2.com
>
>
>
> No virus found in this incoming message.
> Checked by AVG - www.avg.com
> Version: 9.0.872 / Virus Database: 271.1.1/3470 - Release Date: 02/26/11 14:34:00
>
> _______________________________________________
> MR2 Mailing List
> MR2 at mr2.com
> http://mr2.com/mailman/listinfo/mr2_mr2.com
>
>
>
>       
>
> _______________________________________________
> MR2 Mailing List
> MR2 at mr2.com
> http://mr2.com/mailman/listinfo/mr2_mr2.com
>
>