[MR2] Exhaust flexi

[Donald Chalfant]

Notice where you encountered them!  
----- Original Message ----- 
From: "Angus Harvey" <cheekeychavie at googlemail.com>
To: <mr2 at mr2.com>
Sent: Tuesday, September 29, 2009 2:37 PM
Subject: [MR2] Exhaust flexi


> What problems will I encounter if I weld a solid section of pipe,
> where the flexi section is(due to it blowing)?
> 
> I have seen that other ppl have also done this on some motors I
> encountered in the scrap yard!
> 
> _______________________________________________
> MR2 Mailing List
> MR2 at mr2.com
> http://mr2.com/mailman/listinfo/mr2_mr2.com
>